Hard Bond Remover
1 Product
Walker Tape® Hard Bond Remover – For Misapplications Only
Correct hard bond adhesive errors quickly with Walker Tape® Hard Bond Remover—made for professional use in emergency misapplications before adhesives set.
Walker Tape® Hard Bond Remover is designed exclusively for emergency use. It quickly breaks down hard bond adhesives in cases of misapplications or accidental contact with unintended surfaces. Not intended for full system removal, this fast-acting solution gives professionals a reliable way to correct mistakes before the adhesive fully cures.
Flammable – Do not store or use near heat, sparks, or open flame. Use in a well-ventilated area. Close lid tightly. Do not apply to broken, cut, or irritated skin. External use only, do not ingest. Avoid eye contact. Keep out of reach of children.
- Not made for full hair system removal. Do not use on systems, as it may cause damage.
- Hard Bond Remover is not intended, and should not be used as, a remover for full hair system removal.
- Not tested as skin-safe. Use only in misapplications or emergencies.
Waker Tape®'s Hard Bond Remover is made for removing hard bonds from unintended areas, misapplications, or emergencies.
- Systems: Do not use on systems, may cause damage.
- Gentleness: Not tested as skin-safe.
- Flammable
1. Apply the remover, saturate the area where hard bond has been applied.
2. Not intended for full system removal, removing systems once glue has dried.
3. Only for immediate mistakes, misapplications, and emergencies.
Is Hard Bond Remover safe to use on skin?
No. Hard Bond Remover is not tested or approved for use on skin. It should only be applied to tools, surfaces, or areas where hard bond adhesive has been misapplied. Contact with skin or hair systems should be avoided.
When should I use Hard Bond Remover?
Use only in emergency situations—such as when hard bond adhesive is accidentally applied to the wrong area or begins to cure in an unintended location. This product is not intended for full system removal and should only be used before the adhesive has fully set.
How do I clean the area after using Hard Bond Remover?
After use, thoroughly wipe the affected area and then wash with soap and water to remove any remaining solvent. Ensure the area is fully cleaned before proceeding with any reapplication of adhesive or system installation.
